[. . . ] Model name indication position See “Removing the trim plate” (P. 2 Before use Precautions #WARNING ÑÑ prevent injury or fire, take the To following precautions: • To prevent a short circuit, never put or leave any metallic objects (such as coins or metal tools) inside the unit. € Do not watch or fix your eyes on the unit’s display when you are driving for any extended period. € If you experience problems during installation, consult your KENWOOD dealer. [. . . ] Indb 18 2017/09/07 13:46 Installation Installation Before Installation Before installation of this unit, please note the following precautions. #WARNINGS • If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. € Do not cut out the fuse from the ignition wire (red) and the battery wire (yellow). Do not touch the metal part of this unit during and shortly after the use of the unit. € Secure the wires with cable clamps and wrap vinyl tape around the wires that comes into contact with metal parts to protect the wires and to prevent short circuit. € Connect the speaker wires correctly to the terminals to which they correspond. The unit may be damaged or fail to work if you share the ¤ wires or ground them to any metal part in the car. € When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). For example, if you connect the ¢ connector of the left speaker to a front output terminal, do not connect the ¤ connector to a rear output terminal. € After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. € Do not press hard on the panel surface when installing the unit to the vehicle. € Reception may drop if there are metal objects near the Bluetooth antenna. ✎✎ NOTE • Mounting and wiring this product requires skills and experience. € Do not install the unit in a spot exposed to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. € If the power is not turned ON (“There is an error in the speaker wiring. € is displayed), the speaker wire may have a short-circuit or touched the chassis of the vehicle and the protection function may have been activated. € If your car’s ignition does not have an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wire to a power source with a constant voltage supply, such as with battery wires, the battery may be drained. € If the console has a lid, make sure to install the unit so that the front panel will not hit the lid when closing and opening. € If the fuse blows, first make sure the wires aren’t touching to cause a short circuit, then replace the old fuse with one with the same rating. [. . . ] For USA This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. Ñ (Industry Canada) Notice IC This device complies with Industry Canada licenceexempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and t (2)  his device must accept any interference, including interference that may cause undesired operation of the device. CAUTION This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. [. . . ]